 | | Re: Building help for set 392 Formula 1 racer
|
|
Dave, It looks to me as if that stack of 1x2, 1x2, 1x1 are centered on the back 2x3 plates (top and bottom) of the intake scoop, so simply close off the rear of the scoop. As to why they used a 1x1 on the top (or didn't just use a 1x1 or 1x2 brick), (...) (19 years ago, 7-Jan-07, to lugnet.general)
|
| |
| | Re: Improving the firmware?
|
|
Hi all, I doubt this will go through, as I've never been able to post anything to this group yet... I know that the group of us working on the Transterpreter[1] are actively interested in collaborating on such an effort. While the kinds of (...) (19 years ago, 7-Jan-07, to lugnet.robotics.nxt)
|
| |
| | Re: Connect BT devices to the NXT without a passkey?
|
|
In article <025201c73045$8574a7...kdesktop>, Dick Swan <dickswan@sbcglobal.net> writes (...) This is true. (...) The pre-approved Bluetooth low level stack is proprietary to CSR. The code that runs in CSR's Virtual Machine to implement the serial (...) (19 years ago, 7-Jan-07, to lugnet.robotics.nxt)
|
| |
| | Re: Prepare to cry: 2007 train pics
|
|
(...) Sure no problem. The 1/8in brass U channel I have used in the past is easily obtainable at most hobby shops. However I have found it in may other locations including ace hardware and hobby lobby. It’s even available in lengths up too 3 ft but (...) (19 years ago, 6-Jan-07, to lugnet.trains, FTX)
|
| |
| | Re: Warsaw Tram Lw #541
|
|
(...) Unfortunately adding another layer is not really an option (without changing the lines or altering the structure) but I took of the layer of clears and raised the windows by one and it looks better even if it loses the top windows. Thanks for (...) (19 years ago, 6-Jan-07, to lugnet.trains, FTX)
|
