 | | Re: T3 Board colors & rules
|
|
(...) No need to do that. My prototype sits completely behind the board. It doesn't extend along either side of the board. Speaking of which, I finished up the controls last night. I've just got a little bracing I'd like to do then it is on to (...) (20 years ago, 22-Nov-05, to lugnet.org.us.laflrc)
|
| |
| | Tidningsartikel om mitt lego
|
|
Hej allihopa. Nu äntligen har jag kommit med i lokaltidningen.Det blev en ganska stor artikel med en fin översiktsbild av tåget.Här kommer en länk (URL) Hoppas ni gillar det ni läser dock är det en del fel som jag pratat med inblandade om.Ha det så (...) (20 years ago, 22-Nov-05, to lugnet.loc.se, FTX)
|
| |
| | Re: Random Pneumatic idea/question
|
|
(...) Yes, I was wondering what method should be used to bleed them successfully. The clamp idea is a good one. My compressor is very basic. I don't have buggy motors. To build the pressure/vac engine all you would have to do, I assume, is split the (...) (20 years ago, 22-Nov-05, to lugnet.technic)
|
| |
| | Re: Random Pneumatic idea/question
|
|
(...) You will undoubtedly have to bleed the air out of the system when you put in your hydraulic fluid. Otherwise the system won't perform as well. (...) Kev (20 years ago, 22-Nov-05, to lugnet.technic)
|
| |
| | Re: Random Pneumatic idea/question
|
|
(...) Hi Billy, Well, my recollection of a composite five port switch was faulty. When I tried to create a two piston timing circuit (precursor to motor), it would leak because all four switches would be on, letting pressure directly through to (...) (20 years ago, 22-Nov-05, to lugnet.technic)
|
