|
|
 | | Re: 68HC811E2 Can't be set
|
| I ran into the same problem. I was unable to set it with any of the utilities for the handyboard. I ended up using my mini-board and its download software to correctly set the register. I don't know why it worked. Andy hobbytec@cas.auracom.com (...) (26 years ago, 2-Apr-98, to lugnet.robotics.handyboard)
| | | | | Re: Servos
|
| (...) This won't work, as the servo's require a one-shot, not a variable duty cycle type of pwm (like what comes from the motor drivers on the HB). ie. the width of any given pulse is not consistent, just the overall duty cycle. RC servo's require a (...) (26 years ago, 2-Apr-98, to lugnet.robotics.handyboard)
| | | | | Re: 68HC811E2
|
| Thanks John, but I can't believe that, it must be a way there, to alter the CONFIG register ! Erwin (...) (26 years ago, 2-Apr-98, to lugnet.robotics.handyboard)
| | | | | Re: 68HC811E2
|
| Hi Quinn, You are right, my CONFIG is also at 0xFF and try'd all to alter it but without success. Thanks Erwin. (...) (26 years ago, 2-Apr-98, to lugnet.robotics.handyboard)
| | | | | Re: 68HC811E2
|
| Thanks Clancy, but I tryed this already and without success. The hbdl loader says "Invalid CONFIG reg (0xFF) Try again" and when I check the eeprom area with PCBUG11, it is already there. I think, the E2 has a special protection for the CONFIG reg. (...) (26 years ago, 2-Apr-98, to lugnet.robotics.handyboard)
|
|
