 | | Disconnections etc.
|
|
I have a few problems with the Handyboard I just put together: 1. I lose contact with the board from IC very often. Then, when I try to reset the board it will not always reboot. One of the following usually happens: a) I just get the single line of (...) (27 years ago, 16-Mar-98, to lugnet.robotics.handyboard)
|
| |
| | An answer from Polaroid
|
|
A while back I asked if anyone knew about a socket to accomodate the 9-pin plugs that come with the Polaroid sonar modules. I feel pretty dumb now, because I talked with the people at Polaroid, who tell me that it's not really a plug at all; it's (...) (27 years ago, 16-Mar-98, to lugnet.robotics.handyboard)
|
| |
| | Re: How i can beep the handy in Imgecraft C....
|
|
Hi German, I sent this to you before, but I guess you didn't keep it. This one is going to both the robot-board and handyboard lists you can always find it again later by searching the archives for these lists. To beep the beeper using ImageCraft C (...) (27 years ago, 16-Mar-98, to lugnet.robotics.handyboard)
|
| |
| | Re: pneumatics
|
|
(...) Small pneumatics are tough because commercial actuators are (A) expensive and (B)they assume a stationary machine tied to "shop air", i.e. miniature mobile compressors/regulato.../receivers are nonexistant. HOWEVER; you still have 3 good (...) (27 years ago, 16-Mar-98, to lugnet.robotics.handyboard)
|
| |
| | Re: Gear Motors
|
|
(...) Check out Herbach and Rademan at www.herbach.com for surplus DC gearhead motors. They often have 6-24 volt, optically encoded motors for $20-$25 each. J.V. -- ***...*** * John Vaughn Phone: 315-781-3906 * * Dept. of Math & Computer Science (...) (27 years ago, 16-Mar-98, to lugnet.robotics.handyboard)
|
