|
| | 68hc811e2 config reg.
|
| My handyboard works great,with a 68HC11A1 mcu. The config of the 103f register was done in one try and had no problems. I then installed a 68HC811E2 MCU, (a 2k EEPROM version of the original). Using DLM, HBDL and PCbug to try set the config register (...) (27 years ago, 4-Feb-98, to lugnet.robotics.handyboard)
| | | | re: pcode that works without LCD
|
| For the freeware IC, see (URL) Fred (27 years ago, 3-Feb-98, to lugnet.robotics.handyboard)
| | | | 6.270 ROBOT COMPETITION
|
| FF> If you're making a family outing of it, my advice is to show up no FF> later than 4:30, drop the advance party off at the Mass Ave entrance FF> to get in and hold seats, and then have the remaining party park the FF> car and show up with pizza (...) (27 years ago, 3-Feb-98, to lugnet.robotics.handyboard)
| | | | icw 3.2
|
| I tried to intall IC into a directory with a space in it's name and it didn't let me. Did this happen to anyone else? ---...--- ericson mar Master of Engineering Candidate Project: Mobile Robotics mar@cooper.edu (212)353-4356 Department of (...) (27 years ago, 2-Feb-98, to lugnet.robotics.handyboard)
| | | | Memory Stats
|
| I recently attempted a download of code from IC-3.1 to a Handy Board, including some large arrays and other global variables. I then got an error message that there was an apparent conflict because I had used too much space. While I cleaned things (...) (27 years ago, 2-Feb-98, to lugnet.robotics.handyboard)
| |