 | | Re: Mini Rebound RC
|
|
(...) Just because the motors are small dosn't mean they don't pull a big load. Both Adam Cox and myself have been working with the bulldozer kit (from the robot store) and have found they really heat up the motor driver chips (TI SN754410NE). We do (...) (28 years ago, 26-Mar-97, to lugnet.robotics.handyboard)
|
| |
| | Re: Mini Rebound RC
|
|
check out www.robotstore.com and look under kits. There are gear kits and a bulldozer kit that I used two of for a robot. It is not too fast and it pulls a big load, doesn't pull much current (small motors). You might also try the manufacturers page (...) (28 years ago, 26-Mar-97, to lugnet.robotics.handyboard)
|
| |
| | Re: Analog ports....
|
|
I was aware that IR sensors can only give digital (on/off) information. Using analog ports will not give you any extra information. Perhaps the ON voltage level of your circuit is lower that 5V and that each of your sensor circuits differ in such a (...) (28 years ago, 26-Mar-97, to lugnet.robotics.handyboard)
|
| |
| | Re: Neglection of U8 on Parts List
|
|
Bill is right, U8 is a '374. Peter, where exactly are you looking that you don't see U8 listed? It's there at (URL) post URLs if you're trying to help me maintain the site. Thanks. -Fred In your message you said: (...) (28 years ago, 26-Mar-97, to lugnet.robotics.handyboard)
|
| |
| | Broken DS1233-10?
|
|
Hello! I've started work on my Handy Board again, after a brief wait for the memory to arrive, and as soon as I plugged in the boad, I had a problem. I first noticed when I tried to put the board into bootstrap mode, as detailed at the end of (...) (28 years ago, 26-Mar-97, to lugnet.robotics.handyboard)
|
