 | | Servo.lis
|
|
Can anyone tell me what servo.lis has in it. I have the servo.c file but not the lis file. I saw in an earlier email that there was an lis file too. When I load servo.c there are undefined functions. Any help is greatly appreciated. Thanks, Tom (28 years ago, 6-Mar-97, to lugnet.robotics.handyboard)
|
| |
| | Re: 567 design help needed
|
|
(...) (URL) --Chuck McManis (URL) opinions in this message are those of the author. No warranty as to the suitability or accuracy is stated or implied. Use at your own risk. cmcmanis@netcom.com +1.408.524.4805 (28 years ago, 6-Mar-97, to lugnet.robotics.handyboard)
|
| |
| | Re: Vector2x SPI interrupt driven code
|
|
(...) From my experience, the calibration is only needed if you need absolute heading data. Any non-moving metal in the immediate neighborhood will have a constant effect on the readings. I just care about maintaining the current heading (go (...) (28 years ago, 5-Mar-97, to lugnet.robotics.handyboard)
|
| |
| | Serial Line and Stop Switch
|
|
Hello, I am building a handy board for the first time using the Douglas Electronics boards and parts from various sources. I have been following the assembly instructions with great success but now I'm stuck at the end of section 4.4, Serial Line (...) (28 years ago, 5-Mar-97, to lugnet.robotics.handyboard)
|
| |
| | Re: Vector2x SPI interrupt driven code
|
|
(...) I had troubles with the V2X within 2 inches of some small hobby motors. Lotsa magnet there, but larger motors have more magnet. The calibration is supposed to adjust for "hard iron" disturbances, so just having it bolted to your robot with (...) (28 years ago, 5-Mar-97, to lugnet.robotics.handyboard)
|
