|
| | baud rates
|
| Hi all, I have a question concerning baud rates and the SCI port. I looked in one of the pink books and found the maximum baud rate it shows is 131.072k baud. I need it to be 250k baud. I also noticed that the baud rate is dependant on the crystal (...) (28 years ago, 5-Dec-96, to lugnet.robotics.handyboard)
| | | | Re: SPI code
|
| (...) Just to be clear: the code I have promised is 1200 asynchronous serial output from the HB (from a pin other than its built-in RS-232 out :-), *not* SPI code. Mike is correct in stating the place for info is the 6811 "pink book." See the HB (...) (28 years ago, 5-Dec-96, to lugnet.robotics.handyboard)
| | | | (no subject)
|
| Hi, I get this message attached to some of you guys' mail. Does anyone know what it means? This message contains non-ASCII text, which can only be displayed properly if you are running X11. What follows may be partially unreadable, but the English (...) (28 years ago, 5-Dec-96, to lugnet.robotics.handyboard)
| | | | RE:
|
| (...) Isn't that what the SPI is for? Set one up as master, and all others as slaves. Look in the 'pink' book. I don't know of any existing drivers, but Dr. Fred Martin at MIT has stated he will write some Real Soon Now, maybe January. Keep checking (...) (28 years ago, 5-Dec-96, to lugnet.robotics.handyboard)
| | | | RE:
|
| I am trying to find info on networking HC11's too. If anyone knows where to find example code for networking any type of HC11 board, I'd be interested. (...) (28 years ago, 5-Dec-96, to lugnet.robotics.handyboard)
| |