To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.trainsOpen lugnet.trains in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Trains / 31067
     
   
Subject: 
Re: Converting an Emerald Night to run on 9 volt track
Newsgroups: 
lugnet.trains
Date: 
Fri, 18 Dec 2009 17:09:35 GMT
Viewed: 
16953 times
  

Jordan Bradford wrote:

I've thought about using a 9V motor, too, and personally I'd use it as one of
the trucks on a passenger car, as close to the engine as possible so that it's
still pulling the majority of the train's weight -- assuming you add more cars.
The 9V motor can't really replace anything on the engine because it won't fit
where the pilot and trailing wheels are, and it obviously can't be used in place
of the drive wheels because then the pistons won't work. Using the motor as the
base of the tender is a possibility, but you'll have to modify the tender.

On another note, will the new PF stuff work with my "old" RC train
controller?  As noted previously, the one I ordered is not expected
until April - or I could shell out on eBay/Bricklink.  Also, has anyone
tried to use an "IR blaster" or similar with any of the RC stuff?

   
         
     
Subject: 
Re: Converting an Emerald Night to run on 9 volt track
Newsgroups: 
lugnet.trains
Date: 
Fri, 18 Dec 2009 19:55:49 GMT
Viewed: 
17290 times
  

In lugnet.trains, Peter Naulls wrote:
On another note, will the new PF stuff work with my "old" RC train
controller?

Nope. They use completely different IR protocols, unfortunately.
http://news.lugnet.com/technic/?n=16192

As noted previously, the one I ordered is not expected
until April - or I could shell out on eBay/Bricklink.

I'm waiting for my remote, too. :(

If you have an RCX or NXT, you can program them to send PF-compatible signals to
the PF receiver. The RCX needs different firmware to do this, and the NXT needs
an IRLink sensor such as the one from HiTechnic. See the rest of that thread I
linked above.

   
         
   
Subject: 
Re: Converting an Emerald Night to run on 9 volt track
Newsgroups: 
lugnet.trains
Date: 
Mon, 29 Mar 2010 22:08:13 GMT
Viewed: 
21398 times
  

Peter Naulls wrote:

On another note, will the new PF stuff work with my "old" RC train
controller?  As noted previously, the one I ordered is not expected
until April - or I could shell out on eBay/Bricklink.  Also, has anyone
tried to use an "IR blaster" or similar with any of the RC stuff?

My order with 8879 is now "in progress" and 8879 is back in stock.
However, some of the other PF stuff is back order until May:

https://shop.lego.com/ByTheme/Product.aspx?p=8870&cn=587
http://shop.lego.com/ByTheme/Product.aspx?p=8884&cn=87&d=328

 

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR