| | | | |
Does anyone have a picture or so of the internals of points? I need to but the
switch part of all four points to turning since I want to use memory wire on
it.
| | | | | | | | | | | | | In lugnet.trains, Johan Korten wrote:
> Does anyone have a picture or so of the internals of points? I need to but
> the switch part of all four points to "turning" since I want to use memory
> wire on it.
Hi Johan,
What exactly do you mean with " the internals of points"?
If you mean the inner side of a point when you dismount the bottom plate, then i
can help you, but only from a 9V point (2859), not from the 7996 point.
Perhaps i can place them also on Brickshelf.
Regards,
Ludo
| | | | | | | | | | | | | | | | | For some reason it did not post my reply yesterday.
I want to automate the points. I use the spring to let the tongue of the point
return to its normal state and when I wind a nylon thread or so around a axle it
will put the direction for the train in 'straight forward' position. So all the
four tongues should be in 'turning position' in order for this to work. if the
internal springs are just like the 9V version with metal track than I could just
cut the actuator in half en push one side to the left and the other to the
right, but I want to be sure before damaging the point.
| | | | | | |