To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.trainsOpen lugnet.trains in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Trains / 29572
    Re: 7996 Metalized —Ludo Soete
   (...) Why shoudn't this work? Lead-free solder needs a higher soldering iron temperture, keep this in mind, but it can be used. Why i did use the 60/40 lead solder is that i don't have lead-free solder at home yet. Its intention was also to figure (...) (17 years ago, 4-Oct-07, to lugnet.trains, FTX)
   
        Re: 7996 Metalized —Johan Korten
   Does anyone have a picture or so of the internals of points? I need to but the switch part of all four points to "turning" since I want to use memory wire on it. (17 years ago, 5-Oct-07, to lugnet.trains, FTX)
   
        Re: 7996 Metalized —Ludo Soete
   (...) Hi Johan, What exactly do you mean with " the internals of points"? If you mean the inner side of a point when you dismount the bottom plate, then i can help you, but only from a 9V point (2859), not from the 7996 point. Perhaps i can place (...) (17 years ago, 5-Oct-07, to lugnet.trains)
   
        Re: 7996 Metalized —Johan Korten
   For some reason it did not post my reply yesterday. I want to automate the points. I use the spring to let the tongue of the point return to its normal state and when I wind a nylon thread or so around a axle it will put the direction for the train (...) (17 years ago, 12-Oct-07, to lugnet.trains)
 

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR