 | | Re: HELP! NXT brick flash now read-only!! —Nathan Anderson
| | | | (...) The Atmel SAM-BA downloader, included in their In-system Programmer package: (URL) was using an older version than the one currently available on their site, though (1.7 vs. 1.8). (...) Well, it would be nice to be able to get back IN to the (...) (17 years ago, 4-Feb-07, to lugnet.robotics, lugnet.robotics.nxt)
| | | | | | | | | | Re: HELP! NXT brick flash now read-only!! —Ralph Hempel
| | | | | (...) OK, everybody take a deep breath and slow down. first of all, the SAMBA version I'm using is 1.11, available here: (URL) And for anyone that's going to get busy hacking firmware, this is a great place to start: (URL) Yes, there is a script (...) (17 years ago, 4-Feb-07, to lugnet.robotics, lugnet.robotics.nxt)
| | | | | | | | | | | | Re: HELP! NXT brick flash now read-only!! —Juergen Stuber
| | | | | Hi Nathan, hi Ralph, (...) actually for the adventurous hardware hacker it might be possible to revive it using the ERASE pin. Though in this case, and if you are sure you didn't run the script for setting the security bit, I'd ask LEGO for a (...) (17 years ago, 4-Feb-07, to lugnet.robotics)
| | | | | | | | | | | | Re: HELP! NXT brick flash now read-only!! —Nathan Anderson
| | | | | (...) Juergen et al., Good news, everyone! The nightmare is over. :-) And I got to learn a few things in the process, too! Setting the security bit must have been what I did, although I don't specifically recall it...I do remember that, before I (...) (17 years ago, 5-Feb-07, to lugnet.robotics, lugnet.robotics.nxt)
| | | | | | | | | | | | Re: HELP! NXT brick flash now read-only!! —Juergen Stuber
| | | | | Hi Nathan, (...) clever solution. I actually wondered how to do the debouncing, to get the required (in bold face!) pulse of at least 50ms. (...) :-) Jürgen (17 years ago, 5-Feb-07, to lugnet.robotics)
| | | | | | |
