Subject:
|
Re: Review of 10030 Imperial Star Destroyer
|
Newsgroups:
|
lugnet.reviews, lugnet.starwars
|
Date:
|
Mon, 30 Dec 2002 01:37:25 GMT
|
Viewed:
|
5137 times
|
| |
|
|
"Bryan Wong" <green_paper@hotmail.com> wrote in message
news:H7wB7H.GFs@lugnet.com...
> In lugnet.reviews, Kerry Raymond writes:
> > Errors
> >
> > I don't recall any missing parts. There were no errors in the building
> > instructions, but in some steps the quantity of certain heavily-used • small
> > parts was not stated. As it is easy to visually overlook a small part • being
> > added to a sub-assembly that already has hundreds of parts, knowing how • many
> > should have been used in total in each step is a useful cross-check.
>
> I'm not sure if it was only me, but I noticed some discrepancies with the
> deflector shield domes ("golf balls"). Most steps show one dome flush
> against the edge of the plate it sits on, and the other dome 1 stud away
> from the edge. Can someone else verify this?
>
> At the end I found myself short 1 2x8 lt grey plate. But I probably used
> one where I wasn't supposed to...
>
> -Bryan
Uh? Was it a typo?
I thought i should be like that and built one flush against the edge and the
other 1 stud away. When building I thougth it was a bit strange, but not
everyting on the ship was mirrored from one side to the other...
Have to check the manual again and see if I can see where it SHOULD be :)
Regards
Øyvind Steinnes
|
|
Message has 1 Reply:
 | | Re: Review of 10030 Imperial Star Destroyer
|
| (...) The only things on the ship that aren't perfectly mirrored are the detail 10x1 plates around the large trench, and the 10x2 detail plates on the tower. And those are only assymmetrical because they themselves are mirror images from the left to (...) (21 years ago, 31-Dec-02, to lugnet.reviews, lugnet.starwars)
|
Message is in Reply To:
| | Re: Review of 10030 Imperial Star Destroyer
|
| (...) I'm not sure if it was only me, but I noticed some discrepancies with the deflector shield domes ("golf balls"). Most steps show one dome flush against the edge of the plate it sits on, and the other dome 1 stud away from the edge. Can someone (...) (21 years ago, 29-Dec-02, to lugnet.reviews, lugnet.starwars)
|
13 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
