|
A new version of my Power Functins library and PWM remote are now available at:
http://www.fial.com/bob/lego/PowerFunctions_101.zip
There was some code cleanup and fine tuning. The PWM remote program now goes
from slowest to fasted speed.
give it a try and thanks for all the feed back so far.
RCX 2.0 still probably does not work. I will try fixing it as soon as i get a
2.0 to test with.
In my testing of the Single Pin Clear Set Toggle commands, it seems like you
need to send a command out first that gets the motors running and then send a
Clear Set Toggle command before the time out is over.
Bob
|
|
|
Greetings-
What single book, if any, is considered the standard for LEGO NXT?
-David
|
|
|
David,
Zitat von David C Matthews <lego-robotics@crynwr.com>:
> What single book, if any, is considered the standard for LEGO NXT?
What does "standard for LEGO NXT" mean?
There are a lot of NXT-related books out there already, and they deal
with a variety of different topics (see for instance
http://thenxtstep.blogspot.com/search?q=books ).
I guess the answer to your question depends on what you want to know
about the NXT and the tasks you want to perform with it.
----------------------------------------------------------------
This message was sent using IMP, the Internet Messaging Program.
|
|
|
In lugnet.general, Bob Kojima wrote:
|
A new version of my Power Functins library and PWM remote are now available
at:
http://www.fial.com/bob/lego/PowerFunctions_101.zip
There was some code cleanup and fine tuning. The PWM remote program now goes
from slowest to fasted speed.
give it a try and thanks for all the feed back so far.
RCX 2.0 still probably does not work. I will try fixing it as soon as i get
a 2.0 to test with.
In my testing of the Single Pin Clear Set Toggle commands, it seems like you
need to send a command out first that gets the motors running and then send a
Clear Set Toggle command before the time out is over.
Bob
|
Hey Bob
I have just tested your code, and it works good.But is it possible that you
could write some documentation to your code, it would be nice to fully
understand what your doing.
Best regards
Kim Andersen
|
|
|