|
In lugnet.general, Bob Kojima wrote:
|
|
direct. But I cant get Single output or either of the Single pin
modes to work. Have you had any more luck?
|
The toggle bit is checked in Single output mode (the documentation is not
quite right for this mode) and in both single pin modes. each message is
sent 5 times you need to toggle the toggle bit in every message sent. 0 1 0 1
0 1 0 1 etc.
bob
|
Okay, thanks. I can get Single output Mode to work now. Single pin Mode
may be working too, but Im not sure what to expect from it.
I would expect setting either C1 or C2 would set them to 9V and run a motor
forwards or backwards. Setting them both would stop it.
But it seems if I set them, they do nothing. Unless the motor is already
running. If its running forwards at slow speed, then I set C1, it jumps up to
full speed. But then if I set C2 it keeps running, and if I clear C1 it keeps
running, and in the same direction.
Can you get a motor to run just be setting C1?
Jason R
|
|
|
|
Okay, thanks. I can get Single output Mode to work now. Single pin Mode
may be working too, but Im not sure what to expect from it.
I would expect setting either C1 or C2 would set them to 9V and run a motor
forwards or backwards. Setting them both would stop it.
But it seems if I set them, they do nothing. Unless the motor is already
running. If its running forwards at slow speed, then I set C1, it jumps up
to full speed. But then if I set C2 it keeps running, and if I clear C1 it
keeps running, and in the same direction.
Can you get a motor to run just be setting C1?
Jason R
|
i have not really spent a lot of time trying to figure these modes out. i was
more concerned with getting the PWM to work correctly. im going to spend more
time testing this and will let you know.
bob
|
|
|