 | | Re: Building a three-foot bridge
|
|
Brian, Here's my znap bridge I did. It's pretty sturdy, albeit somewhat heavy as well due to the amount of plates I used on the base.. It's a double 6-wide train bridge. The trick that I did was using the 2x2 brick and half stud pieces combined with (...) (22 years ago, 24-Jan-03, to lugnet.trains, lugnet.znap)
|
| |
| | Re: Building a three-foot bridge
|
|
"Cary Clark" <cary@corp.nospamwebtv.net> wrote in message news:H96p3M.I6q@lugnet.com... (...) run (...) Here are a couple of pictures of the ZNAP bridges Cary built along with one I built. (URL) built the two bridges that cary the trains across the (...) (22 years ago, 24-Jan-03, to lugnet.trains, lugnet.znap)
|
| |
| | Re: Building a three-foot bridge
|
|
(...) Well, Brian, I can say one of my 60 inch long ZNAP bridge twisted and collapse at a train show, with the GFLTC (no pics). Two trains fell 30+ inches to the ground out side in the dirt! The best bet for a ZNAP bridge is to support the track on (...) (22 years ago, 24-Jan-03, to lugnet.trains, lugnet.znap)
|
| |
| | Re: Building a three-foot bridge
|
|
(...) Well there's Wayne Hussey's bridge which was built out of znap (URL) it's a bit longer than you need, but I imagine it would've been impossible to use if it had a twisting problem. Maybe you could adapt his deck construction technique? Also I (...) (22 years ago, 24-Jan-03, to lugnet.trains, lugnet.znap)
|
| |
| | Re: Building a three-foot bridge
|
|
Here is one photo of my lift bridge that has a 32" span (approximately): (URL) holds up very well, and i assume that you could make it even longer if you needed to. -Rob www.cei.net/~rhendrix/lego.html www.msltc.org "Brian Kendig" (...) (22 years ago, 23-Jan-03, to lugnet.trains, lugnet.znap)
|
