Subject:
|
Re: LEGO Capacitors use on Trains?
|
Newsgroups:
|
lugnet.trains
|
Date:
|
Wed, 7 Feb 2001 22:09:53 GMT
|
Viewed:
|
851 times
|
| |
|
|
> Of course, that might be an interesting way to make the train more "speed
> realistic" - it would gain speed more slowly since the capacitor would be
> pulling power from the motor, and it would slow down more slowly since the
> capacitor would be pushing power back into the motor.
>
> IANAEE though... (I am not an electrical engineer!)
You'd have to use a diode. Trust me, it is very unlikely that the cap would be
able to deliver much in the way of power to drive the train (they only hold a
few joules of energy, not much when compared even with the speed of a Lego
train).
I think constant lighting is out for the same reasons, just not enough energy
density in the cap.
James
(IANAEE either, IAAME)
|
|
Message has 1 Reply:
 | | Re: LEGO Capacitors use on Trains?
|
| oups! don't try it or be very carefull. the capacitor is a 1Farad 3Volts max capacitor. that would limit the voltage that you can put your regulator at 3V. If you go past that voltage, you'll end up blowing up your capacitor (quite a messy situation (...) (24 years ago, 7-Feb-01, to lugnet.trains)
|
Message is in Reply To:
| | Re: LEGO Capacitors use on Trains?
|
| (...) How would you wire it so that it would only light the light? I would think that it would try to drive the train at the same time... Of course, that might be an interesting way to make the train more "speed realistic" - it would gain speed more (...) (24 years ago, 7-Feb-01, to lugnet.trains)
|
14 Messages in This Thread:
  
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
