Subject:
|
Re: Help Open 12v switch track motor- doesn't switch
|
Newsgroups:
|
lugnet.trains
|
Date:
|
Tue, 16 May 2000 21:49:40 GMT
|
Viewed:
|
2092 times
|
| |
|
|
In lugnet.trains, James Mathis writes:
> Ben,
>
> Thanks. Any assistance you can provide will be greatly appreciated.
Dear James (and whoever might be interested in this also),
I took the point motor from Ludo and opened it again (was hardly glued now).
And I took a few pictures to put the best of them on my homepage here:
http://www-public.tu-bs.de:8080/~rbeneke/lego/9v_12v/9v_12v.html
Or direct picture link here:
http://www-public.tu-bs.de:8080/~rbeneke/lego/9v_12v/pi463.jpg
You will find a few words there, but I fear it's quite hard to open that point
motors housing without causing greater damage to it.
Kind Regards,
Ben
|
|
Message has 2 Replies:
 | | Re: Help Open 12v switch track motor- doesn't switch
|
| After a couple of hours, my 12volt points motor gray box is opened. I damaged the top cover slightly at its base along the flange at one corner. The damage is a flex/cut through the flange caused by too strong of a cut into the very small gap (...) (25 years ago, 17-May-00, to lugnet.trains)
|
Message is in Reply To:
| | Re: Help Open 12v switch track motor- doesn't switch
|
| Ben, Thanks. Any assistance you can provide will be greatly appreciated. However, I would not want you to re-open a repaired points motor that currently works and risk damaging the box. Perhaps Ludo would be willing to speak to this again? I am (...) (25 years ago, 16-May-00, to lugnet.trains)
|
11 Messages in This Thread:
  
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
