 | | Re: matching motor speeds on mutli-motor trains —Frank Filz
|
| | | (...) I'm not sure that this would cause that much problem unless the mismatch was very bad, unless you're really stressing out the motors with long trains (though I doubt we ever really get close to the load capacity of the motors due to the (...) (25 years ago, 27-Mar-00, to lugnet.trains)
|
| | | |
| | | | | Re: matching motor speeds on mutli-motor trains —Steve Bliss
|
| | | | (...) Another way, perhaps not as accurate, but possibly more exciting would be to set up a largish oval of track, with power connection(s) symmetrically positioned. Put the motors back-to-back at one of the power connections, and run the motors (...) (25 years ago, 27-Mar-00, to lugnet.trains)
|
| | | | |
| | | | | | Re: matching motor speeds on mutli-motor trains —Dean Husby
|
| | | | (...) I would recommend running 1 motor with a standard payload. Put it at the start of the track. Then time how long it takes to get to point B. Switch motors and repeat. Also. You can also set the power for an amount of time. Then measure to see (...) (25 years ago, 27-Mar-00, to lugnet.trains)
|
| | | | |
