 | | Re: New Flexible Track Pieces (was: Has anyone considered molding track ourselves?)
|
|
Thanks for digging up that picture! Now we know how it's supposed to be used. I'm betting this is going to rock!!! Myself? I'll probably just go for lots of 2x2 gray tiles under the track. Can't wait for the new track pieces!!! -Stefan- (16 years ago, 13-Mar-09, to lugnet.trains, FTX)
|
| |
| | New Flexible Track Pieces (was: Has anyone considered molding track ourselves?)
|
|
(...) Here is a further picture, showing 64 flexible track pieces in set 8867. The gaps between the two halves of each track piece are smaller than in the previous picture, and there are fewer studs for attaching ballast: (URL) To ballast it means (...) (16 years ago, 13-Mar-09, to lugnet.trains, lugnet.parts.mod, lugnet.loc.uk, lugnet.announce, FTX)
|
| |
| | Re: Has anyone considered molding track ourselves?
|
|
(...) With a little modding to the internal curves of the parts shown in the picture above, it might be possible to support ballast from underneath the track like this: (URL) Mark (16 years ago, 9-Mar-09, to lugnet.trains, FTX)
|
| |
| | Re: Has anyone considered molding track ourselves?
|
|
In lugnet.trains, Stefan Garcia wrote: <snip> (...) I've looked at doing different track sections consistently with the old style 9v track (with the metal on top). Putting the metal on top is a very expensive proposition and found the whole scenario (...) (16 years ago, 9-Mar-09, to lugnet.trains)
|
| |
| | Re: Has anyone considered molding track ourselves?
|
|
(...) I think some people have investigated this in the past for 9V and found that the cost was to great to warrant proceeding. That said, it is probably more feasible for the 'RC Track' since you would not have to deal with the metal rails. (...) (16 years ago, 9-Mar-09, to lugnet.trains, FTX)
|
