 | | Re: Western Train with instructions
|
|
(...) The final two stages are now up (URL) Loco and tender - (URL) (as (URL)) Passenger - (URL) ((URL)) Lumber- (URL) ((URL)) Boxcar - (URL) ((URL)) Caboose - (URL) ((URL)) Please note I've also resubmitted instructions for the Loco (and boxcar and (...) (16 years ago, 16-Dec-08, to lugnet.trains, FTX)
|
| |
| | Re: Western Train with instructions
|
|
(...) Ahhh I found them. The original loco and the last two. I must have accidentally switched LPub across to a different setting before doing (and redoing in the case of the loco) the instructions. Newer versions will be uploaded. Tim (16 years ago, 16-Dec-08, to lugnet.trains, lugnet.cad, FTX)
|
| |
| | Re: Western Train with instructions
|
|
(...) So do I but going back to the original issue which instructions are using the black edgelines? Tim (16 years ago, 16-Dec-08, to lugnet.trains, lugnet.cad, FTX)
|
| |
| | Re: Western Train with instructions
|
|
(...) I agree fully with Philo's thoughts about the "Always black" edgelines. cu mikeheide (16 years ago, 16-Dec-08, to lugnet.trains, lugnet.cad, FTX)
|
| |
| | Re: Western Train with instructions
|
|
(...) I always considered that "Always black" was unusable since dark colors were illegible. So for me the answer is yes. I would be tempted to push the threshold further: even if there is enough contrast on screen, it could be insufficient in (...) (16 years ago, 16-Dec-08, to lugnet.trains, lugnet.cad, FTX)
|
| |
| | Re: Western Train with instructions
|
|
(...) I agree that dark gray would have worked better for these edge lines. I can easily change "always back" in LDView to be "usually black". I played around with the settings a bit, and with r * 30 + g * 59 + b * 11 <= 3600 as my threshold for (...) (16 years ago, 16-Dec-08, to lugnet.trains, lugnet.cad, FTX)
|
| |
| | Re: Western Train with instructions
|
|
(...) See the difference between your instructions and those I created from the MPD: (URL) guess is that your LDView lpub setup has edge lines set to "always black" Philo (16 years ago, 16-Dec-08, to lugnet.trains, lugnet.cad)
|
| |
| | Re: Western Train with instructions
|
|
(...) Thanks! Strange. The edgelines show up very clearly on my system. I'm curious how other people find them? They're set to something similar to dark grey. Tim (16 years ago, 16-Dec-08, to lugnet.trains, lugnet.cad, FTX)
|
| |
| | Re: Western Train with instructions
|
|
Hi Tim, Wonderful models and instructions! (no I'm not turning train ;o)... But I find the edgelines of black parts much too dark, making these parts illegible. What setup did you use? Philo (16 years ago, 16-Dec-08, to lugnet.trains, lugnet.cad, FTX)
|
| |
| | Stage III Re: Western Train with instructions
|
|
(...) --snip-- Stage III is up now. (2 URLs) ((URL)). Tim (16 years ago, 16-Dec-08, to lugnet.trains, FTX)
|
