 | | Re: Scratch building a motor —Ondrew Hartigan
|
| | | (...) anyone care to chime in on how this setup does with pulling power? ondrew (17 years ago, 19-Feb-08, to lugnet.trains)
|
| | | |
| | | | | Re: Scratch building a motor —Jean-Marc Nimal
|
| | | | (...) Well, bear in mind I'm no train expert myself - and that this setup was thrown together a bit hastily; in particular, one gear train was too loose and would do an horrible noise when tortured. That said, I used it to pull a few of Ludo Soete's (...) (17 years ago, 19-Feb-08, to lugnet.trains, FTX)
|
| | | | |
| | | | | | Re: Scratch building a motor —Didier Enjary
|
| | | | | (...) Hi, On the subject, be sure to check Steve Barile's RailBricks #2 article about the PFS train. (page 6-7) - (URL) been able to point this at Jean-Marc but that's (AFAIK) an original idea by Steve. Lot of friction on the rails can be a goal. (...) (17 years ago, 19-Feb-08, to lugnet.trains, FTX)
|
| | | | | |
| | | | | | Re: Scratch building a motor —Jason J Railton
|
| | | | (...) What I'd like to know about this set-up is how it copes with going over points. I've taken track power up into a mechanism through the pivot-point of a bogey, but I haven't powered a truck down through the pivot point like this. I can see that (...) (17 years ago, 20-Feb-08, to lugnet.trains, FTX)
|
| | | | |
