 | | Re: 7996 Metalized
|
| (...) Now that is what I call "out of the box" thinking. Tommy Armstrong (17 years ago, 4-Oct-07, to lugnet.trains, FTX)
| | | | | Re: 7996 Metalized
|
| (...) I covered my 7996 with copper foil tape that I found at Hobby Lobby in their stained glass section. They offer several different widths, all about $5 a roll (which is about 30m of the tape - plenty to do 7996. I was concerned about tinning the (...) (17 years ago, 4-Oct-07, to lugnet.trains, FTX)
| | | | | Re: 7996 Metalized
|
| (...) Why shoudn't this work? Lead-free solder needs a higher soldering iron temperture, keep this in mind, but it can be used. Why i did use the 60/40 lead solder is that i don't have lead-free solder at home yet. Its intention was also to figure (...) (17 years ago, 4-Oct-07, to lugnet.trains, FTX)
| | | | | Re: 7996 Metalized
|
| Does anyone have a picture or so of the internals of points? I need to but the switch part of all four points to "turning" since I want to use memory wire on it. (17 years ago, 5-Oct-07, to lugnet.trains, FTX)
| | | | | Re: 7996 Metalized
|
| (...) I went to a local stained glass studio and picked up a roll of Venture Tape Silvered Copper Foil last night. The widest the shop had was 1/4" so that is what I got. The tape is availible in other widths, and if they had the 3/8" wide, I would (...) (17 years ago, 5-Oct-07, to lugnet.trains, FTX)
| | | | | Re: 7996 Metalized
|
| (...) Hi Johan, What exactly do you mean with " the internals of points"? If you mean the inner side of a point when you dismount the bottom plate, then i can help you, but only from a 9V point (2859), not from the 7996 point. Perhaps i can place (...) (17 years ago, 5-Oct-07, to lugnet.trains)
| | | | | Re: 7996 Metalized
|
| (...) I ran a similar experiment using 4.5v track, and repeated it with some of the RC track. (URL) I built a oval of track with half being new 9v track and the other foil covered RC track. I cleaned the track with a bit of rubbing alcohol. I ran a (...) (17 years ago, 8-Oct-07, to lugnet.trains, FTX)
| | | | | Re: 7996 Metalized
|
| For some reason it did not post my reply yesterday. I want to automate the points. I use the spring to let the tongue of the point return to its normal state and when I wind a nylon thread or so around a axle it will put the direction for the train (...) (17 years ago, 12-Oct-07, to lugnet.trains)
| |
