 | | Re: LDD Model of GG-1 Electric Locomotive - Advice Requested
|
| (...) Glad that you ordered the GG1! This isn't the first complaint about instructions generation in LDD, unfortunately. I would suggest trying the different instructions modes (there's one for vehicles, buildings, and Technic) to see if you have (...) (18 years ago, 30-Apr-07, to lugnet.trains, lugnet.cad.ldd, FTX)
| | | | | Re: LDD Model of GG-1 Electric Locomotive - Advice Requested
|
| (...) NOW you tell me :-) Actually I managed to get it built, but it wasn't easy. (...) That doesn't seem to help, as I did a fresh install of the program last night just for this - my wife's Mac didn't have it installed. (...) OK, I will do that (...) (18 years ago, 30-Apr-07, to lugnet.trains, lugnet.cad.ldd, FTX)
| | | | | Re: LDD Model of GG-1 Electric Locomotive - Advice Requested
|
| (...) A brief update ... I got it built a while ago but only today tried putting it on the tracks. Bad news, I'm afraid. To make it work on LEGO curves, you need to remove the 4x6 tile with technic peg from the 3-axle trucks and add some tiles (...) (18 years ago, 18-May-07, to lugnet.trains, lugnet.cad.ldd, FTX)
| | | | | Re: LDD Model of GG-1 Electric Locomotive - Advice Requested
|
| (...) My (URL) breakdown crane> has 3 axle trucks using standard LEGO wheelsets, and traverses points just fine, although it does have 4 weight bricks holding it down. ROSCO (18 years ago, 18-May-07, to lugnet.trains, lugnet.cad.ldd, FTX)
| | | | | Re: LDD Model of GG-1 Electric Locomotive - Advice Requested
|
| (...) It's also not hinged to another truck; it only has to rotate around its center point. Being attached to the motor truck, the 3-axle trucks in the GG1 are being pulled a little bit off center as the wheels go into the curve, and I think that's (...) (18 years ago, 18-May-07, to lugnet.trains, lugnet.cad.ldd, FTX)
| | | | | Re: LDD Model of GG-1 Electric Locomotive - Advice Requested
|
| (...) Bruce Chamberlain postulated that the problem is due to one of the 3-axle trucks being *pushed* through the curve rather than pulled. I suspect that a rubber band between the two 3-axle trucks would help - I will try that sometime. --Bill. (18 years ago, 19-May-07, to lugnet.trains, lugnet.cad.ldd, FTX)
| |
