 | | Re: Review of 7897 Passenger Train available at ILTCO site
|
|
(...) I think Ondrew was talking about the "time-out" mentioned somewhere, that the IR electronics switches off after a certain time if there's no signal from the controller. I'd be interested in knowing that too. Also, if you get a chance, could (...) (18 years ago, 11-May-06, to lugnet.trains)
|
| |
| | High speed train instructions: not quite an MOC
|
|
(URL) The instructions>. Tim PS. Secrecy inspired by Jason Railton (18 years ago, 11-May-06, to lugnet.trains, FTX)
|
| |
| | Re: Review of 7897 Passenger Train available at ILTCO site
|
|
(...) While you're at it, can you confirm how the motor box is seeled shut, glue, screws or deformed tas like the old 9v motor. Also the new technic axel wheels have the traction tire on them, perhaps that's why they are solid. Pity they didn't redo (...) (18 years ago, 11-May-06, to lugnet.trains)
|
| |
| | Re: Review of 7897 Passenger Train available at ILTCO site
|
|
(...) It struck me as being a lot like the 12V truck, set up to do just that. I could not find the right part to use to try to connect central wheels though. That's a failing of checking every pin type on my part though. (it would be an axle/pin (...) (18 years ago, 11-May-06, to lugnet.trains)
|
| |
| | Re: Review of 7897 Passenger Train available at ILTCO site
|
|
"Larry Pieniazek" <lar(at@at)miltontra...t.dot)com> wrote in message news:Iz2ssx.63w@lugnet.com... (...) Would you comment on the center hole between the two motor wheels on the powered truck? Is it possible to utilize those holes to make a six (...) (18 years ago, 11-May-06, to lugnet.trains)
|
