To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.trainsOpen lugnet.trains in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Trains / 26735
26734  |  26736
Subject: 
Re: Spybotic control of train speed regulator
Newsgroups: 
lugnet.trains
Date: 
Fri, 3 Feb 2006 17:19:22 GMT
Viewed: 
4084 times
  
In lugnet.trains, Tom Cook wrote:

   Some basics of the design: - Two throttles controlled by one Spybotics (left and right controlls on remote) - Rubberband tension should be such that they slip rather than tearing it apart. - Using NQC, internal program allows control of both throttles without remote (i.e., on Spybotics brink itself). First throttle controlled by by Touch Sensor and second throttle controlled by Light Sensor (hence the need for the light bulb). - Pics and .dat file: http://www.brickshelf.com/cgi-bin/gallery.cgi?f=166612

This is a very cool setup. Are you useing the Spybot remote, or the RCX remote? I own several spybot moduals, and I’ve thought of controlling points with them. I’ve also seen clubs use remotes to control a kill switch.

Enstead of the light, could you use the touch sensor for both controllers? Press once to address the left, or press twice to address the right controller. Then do the same to address left or right direction on the control knob, and finally hold untill you’ve reached the desired possition.

Then again, a design with enough slip might allow you to mount a gear as an auxillery knob above each controller.

Mat



Message has 1 Reply:
  Re: Spybotic control of train speed regulator
 
(...) I am using the Spybot remote - have not tried the RCX remote. I like the idea of using the Spybot for turnout control (and free-ing up RCX for other stuff), but the Spybot body is so large. I don't see why you couldn't devise a different (...) (19 years ago, 8-Feb-06, to lugnet.trains, FTX)

Message is in Reply To:
  Re: Spybotic control of train speed regulator
 
(...) Some basics of the design: Two throttles controlled by one Spybotics (left and right controlls on remote) Rubberband tension should be such that they slip rather than tearing it apart. Using NQC, internal program allows control of both (...) (19 years ago, 3-Feb-06, to lugnet.trains, FTX)

6 Messages in This Thread:



Entire Thread on One Page:
Nested:  All | Brief | Compact | Dots
Linear:  All | Brief | Compact

This Message and its Replies on One Page:
Nested:  All | Brief | Compact | Dots
Linear:  All | Brief | Compact
    

Custom Search

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR