Subject:
|
Re: Less than 1/2-stud door inset
|
Newsgroups:
|
lugnet.trains
|
Date:
|
Thu, 31 Mar 2005 17:45:05 GMT
|
Viewed:
|
1454 times
|
| |
|
|
In lugnet.trains, James Mathis wrote:
I used a similar thing for the first version of my WAP-5’s grille once:
http://irfca.org/articles/samarth/wap5-grille2.jpg
http://irfca.org/articles/samarth/wap5-grille3.jpg
But I hadn’t really delved into using it for a different door offset, obvious
though it may be. However, I had been toying with the idea of using headlight
bricks in a similar manner for the same application. Nevertheless, its a good
application, thanks for the note :-D
Legoswami
|
|
Message has 1 Reply:
 | | Re: Less than 1/2-stud door inset
|
| (...) Yeah, to use the backside of two 1x1 headlight bricks instead of the Technic brick 1x2 with two side holes might offer a better stiction connection to the "L" brack with 1/2-plate thickness. Thanks. later, James Mathis (20 years ago, 31-Mar-05, to lugnet.trains, FTX)
|
Message is in Reply To:
| | Less than 1/2-stud door inset
|
| Here's an idea for a (URL) door "look" that is inset by less than 1/2-stud>. Sorry if this has been shown before, and I haven't noticed to credit the designer. later, James Mathis (20 years ago, 31-Mar-05, to lugnet.trains, FTX)
|
4 Messages in This Thread:
  
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
