Subject:
|
Re: BNSF MOC
|
Newsgroups:
|
lugnet.trains
|
Date:
|
Wed, 24 Nov 2004 15:31:12 GMT
|
Viewed:
|
2050 times
|
| |
|
|
In lugnet.trains, Jason J. Railton wrote:
| |
In lugnet.trains, Larry Pieniazek wrote:
| |
...
One beef I have with that set is that the cab at 4 studs is way too short,
but the implication is that you end up short of 45 slopes to do a proper 6
stud cab... so I cheated. Can you spot it?
click
this ...
|
Yes. You’ve used two 2x3 slopes on the right-hand side, then a 2x4 on the
other side at the back and made up two studs of slope with the little 1x1x2/3
slopes.
Then you’ve only photographed it from the right, and the one shot that shows
what you’ve done exhibits a cunning degree of camera shake.
|
On the nose.
| |
Frankly Larry, I’m shocked and stunned that you haven’t parted out dozens of
these by now. I thought I was the only one
struggling with just
one.
|
I have two. I did the moc before I did the set build with the other one. I have
3 more on order but they are from the second shipment so are back ordered. 5 is
probably enough, these have the new light grey in them. :-)
|
|
Message is in Reply To:
 | | Re: BNSF MOC
|
| (...) Yes. You've used two 2x3 slopes on the right-hand side, then a 2x4 on the other side at the back and made up two studs of slope with the little 1x1x2/3 slopes. Then you've only photographed it from the right, and the one shot that shows what (...) (20 years ago, 23-Nov-04, to lugnet.trains, FTX)
|
5 Messages in This Thread:
 
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
