To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.trainsOpen lugnet.trains in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Trains / 214
213  |  215
Subject: 
Re: 1 speed regulator 2 trains and tracks
Newsgroups: 
lugnet.trains
Date: 
Sat, 5 Dec 1998 23:39:05 GMT
Viewed: 
3069 times
  
On Sat, 5 Dec 1998 23:17:22 GMT, "Dave Jost" <djost@cybertrails.com>
wrote:

> Not an expert in electronics....I think the regulator adjust to the amount
> of current that is drawn by the motors so two regulators would share the
> workload on the same system and if you add more motors on the same regulator
> it would just feed more current without slowing things down???????
> 
> Hey I could be wrong here
> 
> Any ways using commen sense tells you everything has its limits, you may at
> one point add to many motors lights etc and than it would be ouside its
> designed limits which may cause an overload,( Matt Bates already said that
> there is an overload protection, allowing you to overload the darn thing) so
> have fun. I'm sure Lego has tested this thing and would probably not sell it
> if it had only a slight chance of blowing up.(don't think they would want to
> get sued)
> 
> regards
> 
> Dave
> 
> PS where are those electronic hobbyist among us that understand this and can
> explain this thing.


Well, if you draw too much current thru your regulator, You'll most
likely run into the limits of the wall-brick trafo thingy. Whgen that
starts to get hot at prolonged use, beware :)

Jasper
Jasper



Message has 1 Reply:
  Re: 1 speed regulator 2 trains and tracks
 
(...) This comes up a fair bit on a regular basis. Someone needs to write up all that is known and get Matt to add it to his excellent site. Anyway here's what I know. I probably have a 1/2 dozen regulators at this point of various histories (most (...) (28 years ago, 6-Dec-98, to lugnet.trains)

Message is in Reply To:
  Re: 1 speed regulator 2 trains and tracks
 
Not an expert in electronics....I think the regulator adjust to the amount of current that is drawn by the motors so two regulators would share the workload on the same system and if you add more motors on the same regulator it would just feed more (...) (28 years ago, 5-Dec-98, to lugnet.trains)

10 Messages in This Thread:




Entire Thread on One Page:
Nested:  All | Brief | Compact | Dots
Linear:  All | Brief | Compact

This Message and its Replies on One Page:
Nested:  All | Brief | Compact | Dots
Linear:  All | Brief | Compact
    

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR