|
|
 | | Re: drawbridge
|
| (...) I don't follow. It appears your diagonals go in both directions, mirrored about the center of the bridge: (URL) did you mean that your diagonals go from top right to bottom left (looking at the right-half of a span), and the diags on my (...) (21 years ago, 29-Apr-03, to lugnet.technic, lugnet.trains)
| | | | | Re: drawbridge
|
| (...) Ok, here's my idea for a solution for a vertically lifting bridge. All you need is one winch connected to one lifting line. You also need one control line(running off the same motor but geared down 2:1). The lifting line goes up the first (...) (21 years ago, 29-Apr-03, to lugnet.technic, lugnet.trains)
| | | | | Re: drawbridge
|
| (...) i'm using eudora to read and send to the news group. that is probably what my problem is. ¤º°`°º¤ø,¸¸,ø¤º°`°º¤...¤øø¤º°`°º¤ Bob Kojima ko@fial.com (URL) Incorporated Telecom Monitoring Solutions 4343 SW Corbett Ave Portland, OR 97201 (...) (21 years ago, 29-Apr-03, to lugnet.technic, lugnet.trains)
| | | | | Re: drawbridge
|
| (...) your spreadsheet is awesome. it worked great for calculating the length and heights. the only small problem was that the diagonal braces on my bridge all go in one direction, which your spreadsheet does not model. so your spreadsheet could (...) (21 years ago, 29-Apr-03, to lugnet.technic, lugnet.trains)
| | | | | Re: drawbridge
|
| (...) the rails on the lift span are not connected to the rest of the rails. there is a separate power connector run to the rails on the lift span. since the rails are not connected, there slopes on the sides to help keep the rails aligned when the (...) (21 years ago, 29-Apr-03, to lugnet.technic, lugnet.trains)
|
|
