Subject:
|
Re: 12V lego train device electronics FAQ?
|
Newsgroups:
|
lugnet.trains
|
Date:
|
Fri, 10 Jan 2003 13:26:19 GMT
|
Viewed:
|
848 times
|
| |
|
|
Hi Ben,
Thank you for the link to the opened 12V switch control device. It is very
informative. I measured, without openening, the resistance of the coil (if I
remember correctly it was about 55Ohms) but I couldn't really conclude if there
was a diode built-in to protect the circuitry of being baked when the current
to the coils is stopped. It seems that there is no diode in the switch device.
(It might be than in the control unit for the switch... or just LEGO skipped
it at all).
Do you know if the led's in the stop/go 2x3 brick contain a current limitting
resistor. I didn't have time to check this my self...
Guido
|
|
Message has 1 Reply:
Message is in Reply To:
 | | Re: 12V lego train device electronics FAQ?
|
| (...) devices (...) 12V (...) Know about what exactely? A picture about the inside of the 12V remote control point-motor is to be found here: (URL) is used in the automated level crossing and the decoupling station. The switches are only switches, (...) (22 years ago, 9-Jan-03, to lugnet.trains)
|
8 Messages in This Thread:
 
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
