Subject:
|
Re: MicroStriping Inspired by Steve Barile
|
Newsgroups:
|
lugnet.trains
|
Date:
|
Tue, 27 Aug 2002 00:09:21 GMT
|
Viewed:
|
2917 times
|
| |
|
|
In lugnet.trains, James Mathis writes:
> In lugnet.trains, Steve Barile writes:
> > I'd love some more ideas of the implementation of this concept, anyone up to
> > it... So I've been looking for sub 1 plate thick elements. The verticle
> > panel part of a 1x2x1 panel is a 1/2 plate thinkness. The top "plate" of a
> > 1x2x1 titling hinge has less than 1/2 plate thickness and the 1x4x1 lattice
> > fence is thicker than 1/2 plate.
>
> MicroStripe using the 1x2x1 tilting hinge brick:
> Use top part one color and bottom part a different color.
> Need a lot of them! But, when shown flat-side-out, the different colors
> create a MicroStripe. Don't know how to hide the "ends". Here's a picture:
> http://www.brickshelf.com/gallery/jamathis/Trains/TrainsOther/MicroStriping/MicroStripe/v1MicroStripe/hingestripe_v1.jpg
>
> The 1x4x1 lattice fence element is almost 1/3 of the width of a brick (as
> shown by MLCad). Not sure how to incorporate this thickness into a smooth
> construction.
How thick is the vertical bit on the 1x2x1 panel?
ROSCO
|
|
Message has 1 Reply:
Message is in Reply To:
 | | Re: MicroStriping Inspired by Steve Barile
|
| (...) MicroStripe using the 1x2x1 tilting hinge brick: Use top part one color and bottom part a different color. Need a lot of them! But, when shown flat-side-out, the different colors create a MicroStripe. Don't know how to hide the "ends". Here's (...) (24 years ago, 26-Aug-02, to lugnet.trains)
|
13 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
