|
|
 | | Re: Help Open 12v switch track motor- doesn't switch
|
| (...) _small_ iron, using low melt solder, and lots of flux. I use a Antax 18W, 12V iron (but, it is british, so you are not likely to be able to get one). Otherwise, a Temp. Controlled iron, or run a small (25W) iron using a Variac (Variable (...) (24 years ago, 17-May-00, to lugnet.trains)
| | | | | Re: Help Open 12v switch track motor- doesn't switch
|
| After a couple of hours, my 12volt points motor gray box is opened. I damaged the top cover slightly at its base along the flange at one corner. The damage is a flex/cut through the flange caused by too strong of a cut into the very small gap (...) (24 years ago, 17-May-00, to lugnet.trains)
| | | | | Re: Lego layout from the seventies
|
| (...) See if you can?? You mean try NOT to spot any :-/ That's what got me about 1/2-1 hr with a Model Builder at the LLC Grand Opening weekend - my grousing about all the parts in pink, light blue, green, and brown that just weren't purchasable. I (...) (24 years ago, 17-May-00, to lugnet.general, lugnet.trains)
| | | | | Re: Question about Running 12v trains
|
| (...) Ben, we have _got_ to hear the story of this! I used to make paddle "steamers", using Electical tape and Lego (the tape seals the Lego up quite well...except across the bottom...) I don't have any pic's here, and I doubt there are any at (...) (24 years ago, 16-May-00, to lugnet.trains, lugnet.boats)
| | | | | Re: Help Open 12v switch track motor- doesn't switch
|
| (...) At least the long sides, but I fear it have been all four sides.... Regards and good night (0:30 am) Ben (24 years ago, 16-May-00, to lugnet.trains)
|
|
