 | | Re: LTMA vs NMRA
|
|
On Wed, 24 Nov 1999, Frank Filz (<383BEDF8.4E1@mindspring.com>) wrote at 13:54:00 (...) 'scuse me, can someone say what a SIG is, for someone into LEGO trains, but not other sorts, and not in N. America? (25 years ago, 25-Nov-99, to lugnet.trains)
|
| |
| | Re: Sombody got a good deal... and I was out bid
|
|
(...) Congrats... Do you have all the service packs that apply to 9V <devlish grin>? ++Lar (25 years ago, 25-Nov-99, to lugnet.trains)
|
| |
| | Re: Sombody got a good deal... and I was out bid
|
|
(...) I jumped on the LEGO train a little late. So now I'm spending huge $$$ to get caught up. But now I am broke. So Scott, the next one is yours. BTW - Larry, with the addition of this club car, I believe I will be 9v train complete. Russ Redmyer (...) (25 years ago, 25-Nov-99, to lugnet.trains)
|
| |
| | Number of motor units on one loop
|
|
A short while back there was a thread about the number of motor units that would run well on one loop. I've done some playing, and here is what I found: Using up to four motor units increases pulling power with only a small decrease in speed. Five (...) (25 years ago, 24-Nov-99, to lugnet.trains)
|
| |
| | track curves on baseplates (was: Re: More Questions from Another Train Newbie)
|
|
(...) As long as the track is elevated at least one plate, it's easy to put the curves on the baseplates. Just use some 1-stud plates (1x1 or 1x2) and some tiles in places the studs don't line up. As it pertains to this discussion, if the place (...) (25 years ago, 24-Nov-99, to lugnet.trains)
|
