|
|
 | | Re: Does anyone know how to modify a train controler?
|
| (...) My solution was to add a resistor over them (picture later). Yes the lowest is 2.9V. By adding a resistor over them all makes i affect the higher settings more than the lower ones. This is right for less that 2.9V is not enough for the motor (...) (23 years ago, 25-Oct-01, to lugnet.trains)
| | | | | Track combos
|
| Hi all, Can someone tell me what were the reference #s of the two 9V track combos that LEGO used to sell? (does TLC still sell them?) TIA, Pedro (23 years ago, 24-Oct-01, to lugnet.trains)
| | | | | Re: Does anyone know how to modify a train controler?
|
| (...) You are right. I think it's 2.9 volts or there abouts. Anything less and it's too low. Inside is just mis matched resistors. As you turn the knob up it just pulls more of them out of the circuit. Dean (23 years ago, 24-Oct-01, to lugnet.trains)
| | | | | Re: 10001 & 10002 arrived today
|
| (...) Just to put closure on the thread, my 20002 arrived 6 days after speaking to customer service, and it's AWSOME! VIVA LEGENDS!!! (23 years ago, 24-Oct-01, to lugnet.trains, lugnet.lego.direct)
| | | | | Re: Does anyone know how to modify a train controler?
|
| (...) One might think that the settings (based on 9v max) are 1.5, 3, 4.5, 6, 7.5, and 9, but they aren't. I cannot remember where the scale starts on the speed controller, but I think it is around 3V. Below that setting (3V?), there just isn't (...) (23 years ago, 22-Oct-01, to lugnet.trains)
|
|
