| |
In lugnet.castle, Manfred Moolhuysen wrote:
> My LDraw mockup has been modeled with headlight bricks, based on their common
> availability, and because I prefered to point the smooth top surface of the
> tiles 1x2 all upwards in the same direction, instead of alternating bottom
> side and top side up.
Yeah, that was something I wasn't happy about with my idea, but I figured it
wouldn't be so bad if you made sure the hollow-up tiles were covered with
conveniently-placed wine bottles. Fortunately, it's actually possible to leave
open smooth-up tiles when you use the 5-stud bricks instead of the new 3-studs.
Another possible variant on your design would be to use 1x1 TECHNIC bricks with
stud-pins instead of headlight bricks. That would take care of the problem of
not being able to attach the bottles to studs, though it might not be as
structurally sound.
> Sorry for that, I expressed myself a bit sloppy. I meant feasibility of using
> long tiles and keeping these in place or combination of long tiles and bricks
> 1x1 with 3 studs. I believed you on your word (and on my imagination) that
> using 1x1 bricks with 3 studs and only 1x2 tiles would fit.
No problem. Until those 3-studs get released in greater quantities, I'm
thinking that version is effectively off-limits for those with smaller pockets,
but your version and my 5-stud version should be fairly simple to produce.
> Yes, I drawed the principle mockup fairly quickly (during my work break) not
> yet knowing 100% what tiles would end up where. For a real attempt I agree I
> would probably limit the heigth or witdh of the rack so that the maximum
> required diagonal could be made with a single tile 1x8.
I don't think it'd be too difficult to pull off. After all, if you want taller
racks, you can always flip the design up on end and build more skinny sections,
and there really shouldn't be any limit to how long you can extend it in one
direction.
|
|
Message is in Reply To:
 | | Re: A wine rack I made today
|
| It's nice to see such fruitfull and inspiring feedback. (...) My LDraw mockup has been modeled with headlight bricks, based on their common availability, and because I prefered to point the smooth top surface of the tiles 1x2 all upwards in the same (...) (21 years ago, 14-Feb-04, to lugnet.castle, lugnet.general, lugnet.town)
|
15 Messages in This Thread:
 
  
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
