Subject:
|
Re: adding power inlet to technic control center
|
Newsgroups:
|
lugnet.robotics, lugnet.technic
|
Date:
|
Thu, 9 Jan 2003 15:16:01 GMT
|
Viewed:
|
239 times
|
| |
|
|
In lugnet.robotics, Rob Hendrix writes:
> Phil,
>
> I was browsing your site lastnight and found that you have the 8485. I
> couldn't find any pictures to support my theory, but thought that version 2
> of the controller would include a power inlet.
It does. One page of the 8485 instruction manual:
http://library.brickshelf.com/scans/8000/8485/8485-027.html
shows the area on top, the lt gray area above the red A-B buttons where
there are no studs. This is where the 9V input connector is, same size as
the RCX. The connector enters at a downward angle.
The unit also accepts 6 C cells. Since I bought mine from DYA, it came with a
220V wallwart.
-Rob Doucette.
DoucetteNet Falling Bricks on BrickLink
http://www.bricklink.com/store.asp?p=robatworldnet
> I took mine apart lastnight,
> and it looks as though they almost made provisions to add the wiring and
> components on the pc board. Does anyone have a picture of the pc board from
> version 2. I could compare the differences between the two and maybe come
> up with an easy solution.
>
> -Rob
>
> "Philippe Hurbain" <philohome@free.fr> wrote in message
> news:H8FvKA.B76@lugnet.com...
> > > Don't they have that by default? I don't own any but AFAIK it comes with • a
> > > wallwart... Did not know it takes batteries though.
> >
> > The evolution of Control center is inverse of the one of RCX: the first
> > version (http://guide.lugnet.com/set/8094) had no supply input, the second
> > (http://guide.lugnet.com/set/8485) got it...
|
|
Message is in Reply To:
7 Messages in This Thread:
   
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
