Subject:
|
Re: Thinner Diff (was: something i said?)
|
Newsgroups:
|
lugnet.robotics, lugnet.technic
|
Date:
|
Sun, 20 Oct 2002 23:36:37 GMT
|
Viewed:
|
343 times
|
| |
|
|
you could make that one stud thinner by placing it within a framework. now i
have something else to work on... i did recently make on from a 24t gear but
it rotates around one of the four holes off axis and is really only good for
use in a sensor array such as a track alighment system can't remember the
link off hand but i think that i can find an image.
m.
"Brian B. Alano" <alano@bloomington.in.us> wrote in message
news:H49Hq9.65n@lugnet.com...
> In lugnet.robotics, Mike Fusion writes:
> > crossposted to lugnet. technic
> >
> >
> > you will find a new page that has a new differential which has been made
> > thinner and with a lot less gear lash.
>
> After playing with your designs for a bit, I decided to see if I could • make it
> any thinner. I did, but it's a compromise: compared to your thindiff, I • suspect
> mine is looser, less sturdy, and more prone to binding. It is, however, • only 5
> studs total. I would still use yours unless I really had to have it • smaller (or
> I didn't have another 40t gear!).
>
> It's here: http://www.brickshelf.com/cgi-bin/gallery.cgi?f=27110
|
|
Message is in Reply To:
 | | Thinner Diff (was: something i said?)
|
| (...) After playing with your designs for a bit, I decided to see if I could make it any thinner. I did, but it's a compromise: compared to your thindiff, I suspect mine is looser, less sturdy, and more prone to binding. It is, however, only 5 studs (...) (22 years ago, 20-Oct-02, to lugnet.robotics, lugnet.technic)
|
11 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
