Subject:
|
Power Puller wheels
|
Newsgroups:
|
lugnet.technic
|
Date:
|
Mon, 4 Feb 2002 19:56:38 GMT
|
Viewed:
|
494 times
|
| |
|
|
Whats the accepted way of fitting these excellent wheels to a hub based on a
standard axle set up. I've not found any discussion on this, but have
noticed that the belt pulley wheel has the same three stud size - but on its
own its too thin to support an axle end..
What do people do?
Regards
Robin
|
|
Message has 1 Reply:
5 Messages in This Thread:
  
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
