 | | Re: repairing a broken 9v wire?
|
|
(...) From what I hear you don't even need to strip the insulation, there are tangs that press through it to make the connection While you're prying it open you may want to replace it with a really long wire for those cross layout power runs and use (...) (23 years ago, 17-Jan-02, to lugnet.technic, lugnet.robotics)
|
| |
| | Re: repairing a broken 9v wire?
|
|
(...) I recently had same problem and repaired it as above, it but it didn't satisfy me enough. Connection after reassembling isn't as good as it should be. Better way is to solder cable directly to that metal thing and cut the "needles" off. (If (...) (23 years ago, 17-Jan-02, to lugnet.technic, lugnet.robotics)
|
| |
| | Re: repairing a broken 9v wire?
|
|
(...) should (...) The trick to getting a good connection is to ensure that both pieces of the 2x2 connector are precisely parallel to each other when pressing them together - this way I'm achieving close to 100% success rates making up custom (...) (23 years ago, 17-Jan-02, to lugnet.technic, lugnet.robotics)
|
