To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.technicOpen lugnet.technic in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Technic / 6168
    Re: building thicker technic axles —Ray Sanders
   (...) One thing I noticed about Technic Axles is that they seem to have a bit of rational flex. You have to have something with a bit of mass being rotated about the axle to notice it. Look at my znap/technic ferris wheel here ... (URL) The center (...) (23 years ago, 27-Nov-01, to lugnet.technic)
   
        Re: building thicker technic axles —Reinard van Loo
   (...) same thing on the helicoptor rotor I've made. To counter this I made a 'one-direction'-drive that 'slipped' when the motor stooped. See (URL) (fifth item in list) and (URL) the axle driving the rotor also had to bee strengthened. I put an axle (...) (23 years ago, 29-Nov-01, to lugnet.technic)
   
        Re: building thicker technic axles —Ross Crawford
   (...) about (...) the (...) and (...) (URL)Also, the axle driving the rotor also had to bee strengthened. I put an axle (...) note the rotor axle was actually 2 joined axles, and extended about 10 studs without support. ROSCO (23 years ago, 30-Nov-01, to lugnet.technic)
 

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR