 | | Re: Can the touch sensor be used as a momentary switch? (without RCX)
|
|
Shit, the white spaces haven't the same size as in the editor. (perhaps better now) ^ 1 O_/_O 4 | | 2 O O 5 3 O O 6 Rainer (25 years ago, 27-Dec-00, to lugnet.robotics, lugnet.technic)
|
| |
| | Re: Can the touch sensor be used as a momentary switch? (without RCX)
|
|
(...) I may be wrong, but I opened one of them and don't find any resistor ?!?! Are there perhaps different versions of touch sensors ?? Or is the black contact in the switch the resistor ?? (Or is a 500 ohm resistor in the RCX at its input ?) (...) (25 years ago, 27-Dec-00, to lugnet.robotics, lugnet.technic)
|
| |
| | Re: Can the touch sensor be used as a momentary switch? (without RCX)
|
|
(...) It's like this : ^ 1 O_/_O 4 | | 2 O O 5 3 O O 6 ^ - marks the yellow button _/_ should be the switch 1 and 2 are connected 4 and 5 are connected the switch is between 1 and 4 (or 2 - 4 or 1 - 4 or 1 - 5) Understandable ???? Rainer (25 years ago, 27-Dec-00, to lugnet.robotics, lugnet.technic)
|
| |
| | Re: Can the touch sensor be used as a momentary switch? (without RCX)
|
|
"Tony Hafner" <hafhead@PANTSplanetquake.com> wrote in message news:G67yvA.LJ0@lugnet.com... (...) a (...) I (...) No, since it contains a 500 ohm resistor it wouldn't make a very good switch. -a (25 years ago, 27-Dec-00, to lugnet.robotics, lugnet.technic)
|
| |
| | Re: Can the touch sensor be used as a momentary switch? (without RCX)
|
|
(...) I've been thinking about this. It would be great to use it as a switch but I haven't found the logic in it yet. I've used some trial and error to try to find the correct wire positioning but I think I'll have to bring out my multimeter and (...) (25 years ago, 27-Dec-00, to lugnet.robotics, lugnet.technic)
|
