Subject:
|
Re: Got my 8007 - C3P0
|
Newsgroups:
|
lugnet.technic
|
Date:
|
Sun, 17 Dec 2000 17:35:57 GMT
|
Viewed:
|
636 times
|
| |
|
|
"Mr L F Braun" <braunli1@pilot.msu.edu> writes:
> Hmmm...any chance of getting a pic of this piece? If it's what
> I hope it is, mecha leg making has just become a whole lot
> easier. Yes!
Judging from the images we have seen, it is either a ball with an axle
hole in it, or a ball with a 1L axle sticking out from it.
Either way, it is pretty useful!
Fredrik
|
|
Message has 1 Reply:
 | | Re: Got my 8007 - C3P0
|
| (...) Correct, the same size ball on a arm joint of the slizer, but it has a + cut in it to fit an axel in, i am trying to photo it.. Check my website under the link above message (...) -- Michael - - - Please reply on medwards@ukonline.co.uk - - - (...) (24 years ago, 17-Dec-00, to lugnet.technic)
|
Message is in Reply To:
| | Re: Got my 8007 - C3P0
|
| (...) Hmmm...any chance of getting a pic of this piece? If it's what I hope it is, mecha leg making has just become a whole lot easier. Yes! best LFB (24 years ago, 17-Dec-00, to lugnet.technic)
|
7 Messages in This Thread:
  
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
