 | | Pneumatic Pack
|
|
i just ordered the pnuematic pack from s@h, and i plan to put it on my soon-to-be 8880. instead of my wacked "hydralics" effect, this time i plan to add a pneumatic boot. since the reach of the standard 2in cylinder is not enough to raise the boot (...) (25 years ago, 10-Nov-00, to lugnet.technic)
|
| |
| | Pneum Tubing (was Re: Split of 5218 (was Re: Lego US S@H))
|
|
I wonder where Lego gets the tubing from. I doubt they make it themselves. I bet there is some supplier that will sell you 100' roll of it for $10. I have seen many close equivalents, but has anyone found a really good match that is easy to order (...) (25 years ago, 9-Nov-00, to lugnet.org.ca.nalug, lugnet.org.au, lugnet.technic)
|
| |
| | Re: Old pneumatic pistons
|
|
The old pneumatics worker slightly differently. Connections went like this: Hand pump connected to direction valve conn. to switch valve conn. to cylinder The direction valve split the pressure created during a compression stroke from the suction (...) (25 years ago, 9-Nov-00, to lugnet.technic)
|
| |
| | Re: Old pneumatic pistons
|
|
"Juergen Stuber" <stuber@loria.fr> wrote in message news:87ofzpz08v.fsf@loria.fr... (...) They worked like this, when you pumped they get ait pushed in to them or sucked out of them. /Martin (25 years ago, 9-Nov-00, to lugnet.technic)
|
| |
| | Re: Old pneumatic pistons
|
|
(...) I don't know about the old piston but regarding the small one, there is one in 8042 and 8443. (25 years ago, 9-Nov-00, to lugnet.technic)
|
