 | | RE: Six bladed propeller, all in line - no problem
|
|
(...) I've noticed that 1x plates attached to the holes of a 6 hole pulley don't move around very much. So to make a propellor, (with 3 blades offset by one or two plates), attach 3 1x plates to a pulley so they stick straight out. Do the same on (...) (25 years ago, 22-Sep-00, to lugnet.technic)
|
| |
| | Re: Six bladed propeller, pls help.
|
|
(...) cone such as the yellow one found on the exhaust (?) of the 8860 supercar could make a good spinner as well - although it would be better in black or grey, of course. Jennifer Clark (25 years ago, 22-Sep-00, to lugnet.technic)
|
| |
| | Re: Six bladed propeller, pls help.
|
|
(...) No no... It's built from the basic parts like 6-hole small technic pulleys, 1/2 pins and regular plates. This simple design dated from early 1980's, there was no such propellers exist at that time. Look at the picture (URL) for a fuzzy and (...) (25 years ago, 22-Sep-00, to lugnet.technic)
|
| |
| | Re: new LEGO elements (inside the Technic Powerpacks)
|
|
Hi Christian --- xTI@N. thanks for your scans! That gives a good view on the service packs. I will go for the styling- and the pneumatic-set! Keep on bricking! Kind regards, Holger (25 years ago, 22-Sep-00, to lugnet.technic, lugnet.general)
|
| |
| | Re: Six bladed propeller, all in line - no problem
|
|
(...) Et voila indeed! Hope I had the eight 3 blade rotors needed, do they come in black? I have to see if I can find a good source for them. Se my other answer in the original thread for my latest idea. Thanks! TGIF! /Tobbe (25 years ago, 22-Sep-00, to lugnet.technic)
|
