 | | Re: Power Function control with RCX and BrickOS
|
|
Hello Jetro, check this URL: (URL) found it after some googling... Greetings Maico Arts Jetro de Chateau schreef: (...) (16 years ago, 29-Mar-09, to lugnet.general, lugnet.technic, lugnet.trains, lugnet.robotics)
|
| |
| | Re: Power Function control with RCX and BrickOS
|
|
(...) Unfortunately the link no longer works and I can't find it anywhere on your new website either. Is it still available anywhere? Thanks in advance Jetro (16 years ago, 29-Mar-09, to lugnet.general, lugnet.technic, lugnet.trains, lugnet.robotics, FTX)
|
| |
| | Re: Chain Precession Drive - Courtesy of TechnicBRICKs
|
|
(...) Bill Are you missing a part from the ldraw library? 32449.dat is a 1x4 liftarm (without boss) and is in the model as pictured here: (URL) Part) Regards Mike (16 years ago, 23-Mar-09, to lugnet.technic)
|
| |
| | Re: Chain Precession Drive - Courtesy of TechnicBRICKs
|
|
(...) I agree: the input side is connected to the orbiter; the output shaft connects only to the cog. That is exactly the way mine is built. Where I disagree with the LDRAW file is the nature of the liftarm: what is shown is a 1x5 liftarm with only (...) (16 years ago, 23-Mar-09, to lugnet.technic)
|
| |
| | Re: Chain Precession Drive - Courtesy of TechnicBRICKs
|
|
(...) Only the input side of the orbiter is connected to a shaft (via 1x4 liftarm) the output shaft turns freely (via 1x5 liftarm) inside the orbiter and connects to the Cog Only. It should be as shown here: (URL) dont have Ldraw installed on this (...) (16 years ago, 23-Mar-09, to lugnet.technic)
|
