 | | Re: Power Function control with RCX and BrickOS
|
|
(...) Unfortunately the link no longer works and I can't find it anywhere on your new website either. Is it still available anywhere? Thanks in advance Jetro (16 years ago, 29-Mar-09, to lugnet.general, lugnet.technic, lugnet.trains, lugnet.robotics, FTX)
|
| |
| | Re: Chain Precession Drive - Courtesy of TechnicBRICKs
|
|
(...) Bill Are you missing a part from the ldraw library? 32449.dat is a 1x4 liftarm (without boss) and is in the model as pictured here: (URL) Part) Regards Mike (16 years ago, 23-Mar-09, to lugnet.technic)
|
| |
| | Re: Chain Precession Drive - Courtesy of TechnicBRICKs
|
|
(...) I agree: the input side is connected to the orbiter; the output shaft connects only to the cog. That is exactly the way mine is built. Where I disagree with the LDRAW file is the nature of the liftarm: what is shown is a 1x5 liftarm with only (...) (16 years ago, 23-Mar-09, to lugnet.technic)
|
| |
| | Re: Chain Precession Drive - Courtesy of TechnicBRICKs
|
|
(...) Only the input side of the orbiter is connected to a shaft (via 1x4 liftarm) the output shaft turns freely (via 1x5 liftarm) inside the orbiter and connects to the Cog Only. It should be as shown here: (URL) dont have Ldraw installed on this (...) (16 years ago, 23-Mar-09, to lugnet.technic)
|
| |
| | Re: Chain Precession Drive - Courtesy of TechnicBRICKs
|
|
Owen and Mike, The 2825 part connects the input shift with the orbiter. The part that was shown in the original LDRAW model clearly does not work because all its holes are round and so there is no way of transferring torque to the orbiter body. The (...) (16 years ago, 23-Mar-09, to lugnet.technic)
|
