 | | Re: New Crane... —Alvin Brant
|
| | | (...) This is correct. Real cranes have roller bearings that are pinned in place that bear the weight and force of the superstructure where it is connected to the base. (...) I am going to use a threaded axle through the center to hold the plates (...) (17 years ago, 21-Feb-08, to lugnet.technic)
|
| | | |
| | | | | Re: New Crane... —Steven Lane
|
| | | | | (...) Mine has that. (17 years ago, 21-Feb-08, to lugnet.technic)
|
| | | | | |
| | | | | | | Re: New Crane... —Alvin Brant
|
| | | | | | (...) It worked pretty well for me on this one: (URL) all of these: (URL) have had no problems with the two parts coming apart....If you can tell by this pic, the red and white one is holding up a 8421 almost 8 feet away from the center of (...) (17 years ago, 22-Feb-08, to lugnet.technic)
|
| | | | | | |
| | | | | | | | Re: New Crane... —Steven Lane
|
| | | | | | | (...) That's a lot of cranes. Are they all yours? (...) I know I'd like to know. Steve (17 years ago, 22-Feb-08, to lugnet.technic)
|
| | | | | | | |
| | | | | | | | | Re: New Crane... —Alvin Brant
|
| | | | | | | | (...) Yeah, Steve, those are all mine...That was at BF 06' They are all still together with the exception of the truck mounted one. The superstructure and boom is still together, but I tore apart the "truck" part of it to rebuild in the near (...) (17 years ago, 22-Feb-08, to lugnet.technic)
|
| | | | | | | | |
| | | | | | | | | | Re: New Crane... —Steven Lane
|
| | | | | | | | (...) Wish I did. :-) Steve (17 years ago, 22-Feb-08, to lugnet.technic)
|
| | | | | | | | |
| | | | | | | | Re: New Crane... —David Koudys
|
| | | | | | (...) <snip> (...) Oh. My. Goodness!!! That would hurt if it fell on you! Once again the LEGO builders--in whatever theme--never cease to astound me! Nicely done! Dave K (17 years ago, 22-Feb-08, to lugnet.technic)
|
| | | | | | |
| | | | | Re: New Crane... —Thomas Avery
|
| | | | Impressive supply of Technic beams you have there :-) The completed model is going to be a monster. Nice job. (...) I've been checking out the design of the dual CC8800, and it appears to not really require that the turntable resists overturning (...) (16 years ago, 12-Jun-08, to lugnet.technic)
|
| | | | |
| | | | | | Re: New Crane... —Alvin Brant
|
| | | | (...) Yeah, check out my brickshelf folder....I still have all the cranes there with the exception of the 18000...So I have a good bit of beams :D (...) Yeah, I have seen the 2250's do the same thing. One thing that I have noticed about the (...) (16 years ago, 13-Jun-08, to lugnet.technic)
|
| | | | |
