 | | Re: GBC MOC: Track Wheel Reservoir (was Re: Tunnel Mouth / Bridge Arch)
|
|
(...) Hey, very nice Mark! Warning, watching those little balls go around and around in a creation of your own can be... very addictive :-) (...) Nifty. I wouldn't worry at all about having *too much* throughput; since the overall rate is 1 bps, the (...) (18 years ago, 22-Mar-07, to lugnet.technic)
|
| |
| | GBC MOC: Track Wheel Reservoir (was Re: Tunnel Mouth / Bridge Arch)
|
|
(...) I've not made very much GBC before but this was such a nice idea that I thought I'd have a go Brian: (URL) I used 36 tracks with pins on alternate ones to give a maximum 4 balls/second output. This can be reduced easily to the standard 1 (...) (18 years ago, 21-Mar-07, to lugnet.technic, lugnet.loc.uk, lugnet.announce.moc, FTX) !
|
| |
| | Re: Technic Manas Truck
|
|
(...) You've used them nicely there! I agree with the on button issue - so far I've managed to leave them exposed... I thought of using the spare motor point for drop legs, but due to the fact that the manas motors are a little timing innacurate (...) (18 years ago, 21-Mar-07, to lugnet.technic)
|
| |
| | Re: Technic Manas Truck
|
|
(...) Hi Ian, Nice MOC! I agree with you: integrating a Manas is not a simple matter. Here is an idea for you: use the spare function in the trailer's Manas to raise / lower a pair of landing legs (See picture of the real thing here: (URL) that (...) (18 years ago, 21-Mar-07, to lugnet.technic)
|
| |
| | Re: Boosting power in a gear train / torque amplifier
|
|
I think one way to do this uses a differential (URL) and a pole reverser (URL). I don't have a picture to hand but the idea is simple. One side of the differential is connected to the low torque "input axle". The differential housing is connected to (...) (18 years ago, 21-Mar-07, to lugnet.technic, lugnet.robotics)
|
