 | | Need to figure out how to get this motor unit attached.
|
|
(URL) trying to figure out how to attach the new motor assembly and it's one-way drive train shown in pics 0-4 in this folder to the hopper assembly, at the point where the old assembly engaged the hopper itself, in pic 10 in the brickshelf folder (...) (18 years ago, 14-Apr-06, to lugnet.technic)
|
| |
| | Re: Request for info on the Control Lab Interface.
|
|
(...) Thanks for your information! I was also sent via email a very helpful page: (URL) His (URL) Research Page> has source code, which was also helpful. In fact, his ActiveX control might be useful for NQC. I had trouble getting it to connect to my (...) (18 years ago, 12-Apr-06, to lugnet.robotics, lugnet.technic, FTX)
|
| |
| | Re: Request for info on the Control Lab Interface.
|
|
(...) Yes, programs are executed on the PC. (...) Nothing is stored on the device. (...) It resides on the PC. (...) AFAIK, you will need a newer version of ROBOLAB. The older versions (forget which) did not support ControlLab. If you're up to the (...) (18 years ago, 11-Apr-06, to lugnet.robotics, lugnet.technic, FTX)
|
| |
| | Re: Help with converting voltage on circuit board
|
|
(...) Hi Danny, If we supply +12V to the top of the transistors, the drive circuit will most likely not be able to block those transistors completely (unless said drive circuit has an open collector structure with a pull up to the emitter of the (...) (18 years ago, 11-Apr-06, to lugnet.robotics, lugnet.technic)
|
| |
| | Re: Request for info on the Control Lab Interface.
|
|
Just today I got one of these from an eBay auction, including the original cable in a sealed plastic bag. The ROBOLAB software wasn't included, however, so I imagine that I'll need a driver of some kind to use it. Does anyone have a driver? (This (...) (18 years ago, 11-Apr-06, to lugnet.robotics, lugnet.technic, FTX)
|
